Kit for replacement of original electronic board for ACME D143 with PLUX22 decoder connector and PowerPack on board.
Main board for ACME D143
€27,00 _incl. VAT
Description
(Code 4-30126) Main Board for updating the electronics of the ACME D143 site.
Allows the replacement of the old pcb with a newly designed one with these features:
- MainBoard format 16x35mm.
- Decoder connector PLUX22.
- PowerPack: it is a backup energy storage device. Its purpose is to store energy to return it when the site loses electrical contact for short periods. The device helps to maintain the continuity of the power supply avoiding unpleasant reset of the decoders. If you use sound decoders it avoid annoying reset of sounds.
- Speaker with specific case code 4-30206 optional.
- Also available with PLUX22 ESU LokPilot V5 decoder. The MULTIPROTOCOL version can be ordered, with a cost of 2 euros more, writing via email to store@almrose.it.
- Also available with Sound PLUX22 Zimo Multiprotocol decoder with pre-loaded sounds .
- Equipped with LED headlight kits (optional) with the following features:
– Pre-painted plastic headlights.
– LEDs already mounted.
– Transparent plastic porthole for glass simulation.
– Easily replace the original ones.n.b. in case they are used without our main board, it is necessary to provide adequate current limiting resistors for the LEDs.
Analog mode:
- If you use it in analogue mode, remember to have an analogue adapter such as our article 4-30021 (see the recommended products below). The PLUX16 adapter can also be used on the PLUX22 connector, paying attention to correct positioning.
